10 Ton Alum

Putting
On A Few Pounds

Go ahead, put the weight on. Heavy loads are what Danco's 10 Ton
Kodiak Series were made for. The Danco Carriers are built super-tough to
meet your hauling needs. Since 1983 Danco has been supplying the agricultural
and industrial equipment industries with easy, safe, single operator and less
expensive equipment for all your hauling needs.

STANDARD EQUIPMENT

Deck

3/16 Inch Aluminum Diamond Plate Deck
3 Inch Aluminum Channel on 10 Inch Centers
Non-Polished Aluminum Finish
Tie Down Key Slots (4 Front, 4 Rear)
Driver and Passenger - Chain Trays
Stake Pockets Full Length
Heavy Duty Tapered Approach Plate
Steel Bolt-On Cab Protector
12,000 Pound Worm Drive Winch
50 Feet of 1/2 Inch Winch Cable
Bed Anti-Tilt Feature

Subframe

10 Ton Rigid Reinforced Tubular Subframe
Driver and Passenger Side Illuminated Controls
Lubricated Control Handles
Replaceable High Performance Slide Pads
(2) Danco Mud Flaps

Electrical

Federal Standard 108 Lighting
Weather Resistant Electrical System
Back-Up Lights
Interstate Commerce Commission Lights
Back-Up Alarm

Hydraulics

Hydraulic Oil Reservoir
Oil Filter with Cartridge
Hydraulic Pump
Aeroquip Abrasion Resistant Hydraulic Hose
Flexible Hose and Wire Tracking System
Extra Length Push-Off Cylinder
Two Power Lift Cylinders
Chrome Plated Cylinder Rods

General

Dual Adjustable Positive Hold Downs
Lubrication Fittings on All Pivot Points
State of the Art Paint Facility
All Components for Complete Installation
Field Installation and Tested

For More Information:
Printable Version of 10 Ton Kodiak Hauler

OPTIONAL EQUIPMENT

Two Gear Power Take-Off w/ Warning Light
Air Shift PTO
NEW Rumber Decking
5/4 Inch Apitong Wood Deck
Flat Bar on Side Rail with Stake Pockets
102 Inch Wide Deck
Polished Aluminum Cab Protector and Rails
Split Removable Deck Rails
Additional Tie Down Key Slots
Heavy Duty Industrial Cab Protector
Screen In Cab Protector
Enclosed Cab Protector at Bottom
3/16 Inch Aluminum Diamond Plate Over Wood

1/4 Inch Aluminum Diamond Plate Decking
8 Inch Deep Wheel Wells and Covers
Frame Mounted Cab Protector
Marker Light Package In Cab Protector
20,000 Pound Worm Gear Winch
Spring Loaded Cable Tensioner Plate
Wireless Remote Controls
30 or 48 Inch Tool Box with Locking Latch
Subframe Mount Hydraulic Stabilizer Bar
Wheel Lift / Tow Bar / Hitch Receivers / Hitches
Wrecker Special Light Bar w/ Three Inch Risers
Work Light Package
Factory Installation

Many Other Popular DANCO Accessories Upon Request

SPECIFICATIONS

Model	Deck Length	Cab To Axle	Cab To Tandem
20A10T 22A10T 24A10T 26A10T 28A10T 30A10T	20' 22' 24' 26' 28' 30'	120" - 126" 144" - 150" 168" - 174" 192" - 198" 216" - 222 240" - 246"	Not Available 114" - 120" 138" - 144" 162" - 168" 186" - 192" 210" - 216"

Load Rating Main Deck: (Based On Water Level Load)
Minimum Loading Angle:
Maximum Bed Angle:
Decking:
Crossmember Spacings:
Deck Width: Over All Width
Deck Extension:
Winch Rating: (1st Layer)
Winch Cable:
Controls:
Minimum G.V.W.
Maximum G.V.W.

20,000 lbs.
13°
20°
3/16" Steel Diamond Plate
10"
96"
123"
20,000 lbs.
50' x 5/8" Diameter
Driver and Passenger Side Controls
33,000 lbs.
50,000 lbs.

Gross vehicle weight rating limitation must be considered. Ratings are based on structural factors only,
not chassis capacity. Danco specifications shown are approximations and may vary depending on chassis
selected. Danco's body ratings are based on a water level capacity. Product specifications are subject to
change without notice. Some optional equipment may be shown in photographs.
All Prices Are Installed, Freight On Board Greencastle, PA

411 South Cedar Lane
Greencastle, PA 17225
Phone: (717) 597-7185
1-800-453-2626
Fax: (717) 597-7106
E-mail: danco@innernet.net